Group 8 Job Editor Page 341
JET3up Release R1.06
The current display buffer will be printed with each PrintGo signal received unless
you have selected the <Check Double Prints> option.
With the <Check Double Prints>
option activated you will receive an error
message when a PrintGo signal occurs
before a new character string was received.
So it is granted that each character string is only printed once.
The following tables show the data transmission, the buffer content and the print-
out. It also shows how the settings for the wildcards and the offset affect the
displayed characters and therefor the print-out.
The external data can be sent with any terminal software like e.g. Hyperterminal.
You have to make sure that the serial interface parameters of the terminal software
correspond with the parameters of the JET3up interface.
Deleting the input buffer
The current content of the input buffer can be deleted at any time. For this you can
use the respective option in the Drop-down menu <Extra>:
<Extra>-<Production counter>-<ExternText Delete extern text memory>
After the input buffer was deleted it has
to be filled up again completely with
data. Only then the data will be
transferred to the display buffer in order
to be printed.
Deleting the input buffer
To Next Page
