Chapter 5 Memory and Parameter
[Setting Example]
When the machine which is moved by ball screw is connected to the encoder with gear, the setting of the encoder unit /
Encoder Pulses per rotation / Encoder Travel per rotation is as follows.
· Encoder unit: mm
· Encoder Pulses per rotation = Encoder resolution x
Encoder side gear ratio
= 4096 x 7
= 28672 pls
· Encoder Travel per rotation = Ball screw pitch x Machine
side gear ratio
= 10.0 mm x 5
= 50.0 mm
(d) Encoder Pulse input
When wanting to use the encoder signal of servo drive or manual pulse generator as an input, the signal, which is right to the
output form of the encoder or manual pulse generator, can be selected to be used.
One among CW/CCW (x1), PULSE/DIR (x1), PULSE/DIR (x2), PHASE A/B (x1), PHASE A/B (x2), and PHASE A/B (x4)
must be selected and set for the encoder input signal.
To Next Page
Loading...
