LSIS XGT Series - Local Ethernet Connection with XG5000

Chapter 14 Local Ethernet Function
14-4
14.1.2 Local Ethernet Connection with XG5000
After finishing Local Ethernet Parameter settings, download the settings to the motion controller, then user can
connect to XG5000.
Select Online Settings and set the options as shown below figure.
(Notice: Motion controller’s Ethernet port does not support the relay function about remote connection. Then, motion
controller doesn’t support the remote connection.)
Select the connection setting of XG5000. Then, select the options of connection option as below.
Click the setting button to specify Ethernet IP. Click OK after specify the Ethernet IP set before.
User can find the IP information available now.