Chapter 10 CPU Function
10.5 Remote Function
In the motion controller, you can change the operation mode through the key switch attached to the module or
through communication. For remote operation, put the basic unit’s mode change switch on STOP position.
(1) The kinds of remote operations are as below.
• Access to XG5000 and operation through the USB port installed in the basic unit
• You can operate the other motion controllers connected to the network by using the motion controller’s communication
functions when XG5000 is connected to the basic unit.
• You can control the motion controller’s operation status with HMI software, etc. though the dedicated communication
(2) Remote RUN/STOP
• It is the function to execute RUN/STOP through communication modules through the outside.
• This convenient function can be helpfully used when the motion controller is installed in the bad palace to
operate or you need to RUN/STOP the CPU modules of a control panel from the outside.
(3) Remote reset
• It is the function to reset the CPU module by remote control when errors occur.
• 'Reset' and ‘Overall Reset’ are available.
To Next Page
Loading...
