LSIS XGT Series - Export to the SD Card

Chapter 12 SD Additional Function
12-2
12.1.2 Export to the SD Card
Select [XG5000] - [Project] - [SD Card Setting] - [Export to SD Card] to launch the window where you can set
the SD card. (The function, ‘Export to SD card’ is available only when the XG5000 is not online.)
(1) PLC update
The PLC update function is to update the program stored in the SD card to the PLC.
The description of each item in the PLC update mode is as follows.
Item
Description
Target drive
Select the storage medium to store the project data
Select action folder
Location where you will save the project data (folder)
Select operation mode
Set the PLC operations when inserting the SD card
PLC Update: Updating the PLC using the data stored in the SD card
Do not read from PLC
When the PLC project is updated using the SD, ‘Read from PLC’ is
prohibited.
Use PLC password
Check
whether the PLC project can be updated using the SD including the
PLC password setting
Limit PLC usage
Specify the PLC that can update the PLC project
Auto-reset after update is
completed
Whether to execute the PLC reset after the PLC update is completed
PLC status after update is
completed
Set the PLC operation mode after the PLC update is completed