LSIS XGT Series - Start Automatic Operation (Nc_Cyclestart)

Chapter 6 Motion Function Blocks
6-189
6.8.5 Start automatic operation (NC_CycleStart)
Motion Function Block
NC_CycleStart
NcChannelNcChannel
Execute Done
UINTUINT
BOOL BOOL
Busy BOOL
Error BOOL
ErrorID WORD
Input-Output
UINT
NC channel
Set the NC channel to make the command.
Input
BOOL
Execute
Start the automatic operation in the rising Edge.
Output
BOOL
Done
Indicate the state of motion function block completion.
BOOL
Busy
Indicate that the execution of motion function block is not completed.
BOOL
Error
Indicate whether an error occurs or not.
WORD
ErrorID
Output the number of error occurred while motion function block is running.
(1) This motion function block is to execute the automatic operation on the corresponding NC channel under the NC control.
(2) The program set in NC_LoadProgram is automatically operated.
(3) When the automatic operation is stopped due to M00, M01(Optional Stop) and single block, the automatic operation is
restarted.