LSIS XGT Series - Trigger Sample Calculation; Trigger Sample Save Cycle

Chapter 11 Datalog Function
11-50
11.5.3 Trigger Sample Calculation
The item that can be set at the parameter is the total number of trigger sample blocks and the number of sample blocks
before trigger condition. The number of sample blocks after trigger is determined by the two input values
Total Number of Trigger
Samples
= Number of Samples before
Trigger Condition
+
Number of Samples after
Trigger Condition
(Setting Available)
(Setting Available)
(Setting Available)
11.5.4 Trigger Sample Save Cycle
When Trigger Condition occurs, data collected are saved at the sampling interval set by the parameter.
The saving interval is as follows.
 Main task interval, 20ms, 50ms, 100 ms, 200 ms, 500 ms, 1000 ms, 2000 ms
11.5.5 Trigger Sample Save Section
(1) If Trigger occurs after the number of previous data set by the parameter
 Saves data in the number set by the parameter
Caution
After selecting Trigger Save, if the Trigger Condition is again satisfied before data saving is complete, the new
trigger is ignored and the trigger collisions number flag value increases. Trigger Condition is checked after
saving the set number of trigger sample blocks, and then the data are saved.