Chapter 12 SD Additional Function
12.1.7 PLC Boot Operation
This function is to operate the PLC with the program saved in the SD, not the project saved in the PLC. The programs
that were already running are stored in the PLC. If the PLC power is turned off, on after removing the SD card, it is
driven by the existing program again.
If you select ‘PLC boot operation’ in ‘Export to SD card’ and click OK, the writing window will be created as below.
After completing ‘Export to SD card’ successfully, the window indicating successful completion is created and the
saved drive is displayed.
To Next Page
Loading...
