LSIS XGT Series User Manual

Chapter 9 NC Control Function
9-62
9.4 NC Parameter
NC parameter is channel parameter and axis parameter.
The each parameter is as follows.
Parameters
Group
No.
Item
Description
1. Channel
parameters
1. Basic
setting
1
Target machining quantity
Set the target machining quantity.
(0 ~ 2,147,483,647)
2
Target machining quantity
at M99 repeated
machining
Set the target machining quantity for repeated
machining with M99. If the set value matches the
current machining quantity, the cycle automatically
stops.
(0 ~ 2,147,483,647)
3
Check of decimal point
Set whether to check decimal point of the NC
program.
0: Decimal point check
(Mm if there is a decimal point, um if there is no
decimal point)
1: No decimal point check (mm)
4
Keep workpiece
coordinate system
Set whether to keep the workpiece coordinate
system when resetting.
0: Keep
1: Do not keep
5
Whether to call the macro
when the T code is
commanded
Set whether to call the macro program (9000.nc ~
9009.nc) when the T code is commanded.
0: Do not call
1: Call
6
Dwell method
Set the dwell function (G04) to use the data
corresponding to X, P as time or the number of
revolutions of the spindle.
If the data is set to the number of revolutions of the
spindle, it is applied in the status of feed per
revolution (G95).
0: Time
1: Number of revolutions

LSIS XGT Series Specifications

General

Brand	LSIS
Model	XGT Series
Category	Controller
Language	English