Chapter 3 Operation Order and Installation
3.2.2 Installation Environment
This controller has a good reliability regardless of installation environment but cares should be taken in the following
items to guarantee the reliability and safety of the system.
1. Environment Condition
(1) Install the control panel available for water-proof, anti-vibration.
(2) The place free from continuous impact or vibration.
(3) The place not exposed to direct rays.
(4) The place with no dew phenomena by rapid temperature change.
(5) The place where surrounding temperature maintains 0-55℃.
2. Installation Construction
(1) In case of processing the screw hole or wiring, cares should be taken not to put the wiring remnants to
Controller inside.
(2) Install on the good place to operate.
(3) Do not install the high voltage machine on the same Panel.
(4) The distance from duct or surrounding module shall be more than 50mm.
(5) Ground to the place where surrounding noise environment is good enough.
3.2.3 Notices in Handling
Here describes the notices in handling the positioning module from opening to installation.
(1) Do not fall down or apply the strong impact.
(2) Do not remove PCB from the case. It may cause the failure.
(3) In wiring, cares should be taken not to put the wiring remnants or foreign materials to the upper part of
Controller. If something entered, it should be removed.
To Next Page
Loading...
