LSIS XGT Series - Attachment;Detachment of Motion Controller

Chapter 3 Operation Order and Installation
3-5
3.2.4 Attachment/Detachment of Motion Controller
Motion controller must be mounted to hook for fixation properly before its fixation.
The Controller may be damaged from over-applied force. If module is not mounted properly, it may cause malfunction.
 Do not drop or impact the module case, terminal block connector.
 Do not separate PCB from case.
Caution in handling
1. Use motion controller in the range of general specification specified by manual.
2. In case of usage out of range, it may cause electric shock, fire, malfunction, damage of product.
(1) Installation of motion controller
Motion controller has a hook for DIN rail (rail width: 35mm) so that cab be installed at DIN rail.
(a) In case of installing at DIN rail
 Pull the hook as shown below for DIN rail at the bottom of motion controller and install it at DIN rail
 Push the hook to fix the module at DIN rail after installing motion controller at DIN rail
Remark
HOOK for DIN rail