Chapter 3 Operation Order and Installation
(b) In case of installing at panel
You can install motion controller onto a panel directly using screw hole
Use M4 type screw to install the product onto a panel.
This product is designed so that PE and panel come in contact with each other through a screw at the bottom
right of the product. When installing on the panel, be sure to connect the screw in the bottom right side.
(2) Controller equipment locaiton
Keep the following distance between module and structure or part for ventilation, easy detachment and attachment.
Screw for installing at panel
Screw for installing at panel
To Next Page
Loading...
