LSIS XGT Series User Manual

Chapter 11 Datalog Function
11-33
OFF the datalog Enable Flag to stop data saving.
When the SD memory still has data to save, the Log Ending _DLxx_Stoping(%KX8963) flag turns ON, and back
to OFF once all data are saved.
Note
When using Main task save, set the datalog parameters by referring to main task performance cycle.
Setting too much data and too fast interval may cause data loss.
- Main task run time can be verified from the following menu.
[On-line] –[Diagnosis] – [motion controller Information] –[Performance Tab]
11.4.2 Save at Designated Interval
(1) Description of operation
Save at Designated Interval refers to saving data at intervals set by the user. It is different from Main task Save in
that the former collects data at certain intervals, and is capable of saving data that change at certain intervals at more
accurate points.
Time
Data
Save condition
occurrence
Save condition
occurrence
Save condition
occurrence
Current
value: 100
Current
value: 60
Current
value: 120
When a comparison condition occurs,
the data is saved

LSIS XGT Series Specifications

General

Brand	LSIS
Model	XGT Series
Category	Controller
Language	English