Chapter 6 Motion Function Blocks
It indicates that the axis group is in the process of JOG operation.
Indicate that the execution of motion function block is not completed.
Indicate whether an error occurs or not.
Output the number of error occurred while motion function block is running.
(1) This motion function block executes the JOG operation of the coordinate system for the corresponding axis group.
(2) The JOG operation is a manual operation function for testing. It is used for checking system operations, wiring status, and
position address for teaching. It can be respectively applied to both high speed and low speed.
(3) If you change the value set in Low / High when the Enable input is On (JOG operation status), the speed will change without
stopping JOG operation.
(4) If both the forward (Pox_) / reverse (Neg_) inputs are set for the same axis, the axis will stop.
To Next Page
Loading...
