LSIS XGT Series - Page 451

Chapter 8 Motion Control Function
8-60
(2) In case ContinuousUpdate input is On in Edge operation motion function block, the input at the time when Execute input
is On (rising Edge) is applied to the motion function block if Execute input is On, and the motion function block makes a
motion to reflect the change if the input is changed while ContinuousUpdate input is On. However, changes in input are
no longer reflected after the operation of the motion function block is completed or stopped (Busy output disabled).
[Example]Input variable update of the motion control command when ContinuousUpdate is On
(3) In case of the level operation motion function block, input variables at the time when Enable input is On (rising Edge) are
applied to operate, and input variables can be changed continuously while Enable input is On.