LSIS XGT Series - Page 516

Chapter 9 NC Control Function
9-13
Category
Program instruction
Function
G code
instruction
G41
Compensate the tool diameter to the left
G42
Compensate the tool diameter to the right
G43
Compensate the tool length in the direction of +
G49
Cancel compensation of the tool length
G52
Set the local coordinate system
G53
Select the machine coordinate system
G54
Select the workpiece coordinate system 1
G55
Select the workpiece coordinate system 2
G56
Select the workpiece coordinate system 3
G57
Selecting the workpiece coordinate system 4
G58
Selecting the workpiece coordinate system 5
G59
Selecting the workpiece coordinate system 6
G60
Single direction positioning
G90
Absolute command
G91
Incremental command
G92
Set the workpiece coordinate system, the max. speed of the
main axis
G94
Feed mode command per minute
G95
Feed mode command per revolution
G107
Cylindrical interpolation mode setting
G112
Interpolation mode of the polar coordinate ON
G113
Interpolation mode of the polar coordinates OFF
M code
M00
Program stop
M01
Optional stop
M02
PROGRAM END
M03
Forward rotation of the main axis
M04
Reverse rotation of the main axis
M05
Main axis stop
M06
Tool change
M08
Coolant ON
M09
Coolant OFF
M30
End of the program
M98
Auxiliary program call
M99
End of the auxiliary program