LSIS XGT Series - Page 664

Chapter 11 Datalog Function
11-44
Trigger
Occurrence
Condition
Device
Set Condition
Operation Note
Word
Condition
Elevation
Different
Saves data at the elevation edge of the relevant bit, when
the set word device value is different from the in
put set value
Descent
Saves data at the descent edge of the relevant bit, when the
set word device value is different from the input set value
(2) Multiple Condition
Multiple condition refers to setting up to 4 single conditions and operating by performing the operations that fit the
conditions. At least two Single Conditions should be set. Trigger Save begins when operation with the set single
conditions satisfy the result. Multiple Condition runs under AND Calculation, OR Calculation.
Note
When less than 2 single conditions are set for trigger multiple condition, the following error message is
displayed.