Chapter 11 Datalog Function
(b) OR Calculation
Trigger occurs when even one condition is satisfied at a single main task. After selecting Trigger Save, if the
Trigger Condition is again satisfied before data saving is complete, the new trigger is ignored and the number of
collisions flag value increases.
☞ When setting only with BOOL condition
Condition Set Device Trigger Occurrence Condition
Condition 0 BOOL %MX1010
Elevation
Condition 1 BOOL %IX1
Condition 2 BOOL %MX2010
Condition 3 BOOL %QX130
To Next Page
Loading...
