LSIS XGT Series - Page 692

Chapter 11 Datalog Function
11-72
(2) Multiple Condition
Multiple Condition refers to setting up to 4 single conditions and operating by performing the runs that fit the
conditions
Event condition occurs when operation with the set condition satisfies the result
Setting
Operation
Note
AND Condition
Performs AND run with the set conditions, and saves data when the result is 1.
OR Condition
Performs OR run with the set conditions, and saves data when the result is 1.
(a) AND Calculation
Event occurs when all relevant conditions are satisfied at a single scan. The following is an example of activating
Event Save.
☞ When setting only with BIT condition
Condition
Set Device
Event Occurrence Condition
Condition 0
BOOL
%MX1010
Elevation
Condition 1
BOOL
%IX1
Condition 2
BOOL
%MX2010
Condition 3
BOOL
%QX130