Chapter 3 Operation Order and Installation
(4) Requirement to conform to eh Low-Voltage directive
The low-voltage directive requires each device that operates with the power supply ranging from 50V to 1000VAC and 75V
to 1500VDC to satisfy the safety requirements. Cautions and installation and wiring of the motion controller series to
conform to the low-voltage directive are described in this section.
The described contents in this manual are based on the requirements and the applicable standards control. However,
LSIS will not guarantee that the overall machinery manufactured according to the details conforms to the above regulation.
The method of conformance to the EMC directive and the judgment on whether or not the machinery conforms to the
EMC Directive must be determined finally by the manufacturer of the machinery.
1) Standard applied for motion contorller
The motion controller follow EN6100-1 (safety of devices used in measurement rooms, control rooms, or laboratories).
And the motion controller modules which operate at the rated voltage of AC50V/DC75V or above are also developed to
conform the above standard.
To Next Page
Loading...
