Chapter 14 Local Ethernet Function
(3) Enter the user ID and password to be used to access the FTP server.
- You can change the user ID and password through XG5000 only.
(4) Check ‘Display Password’ and verify whether the entered password is correct.
(5) Enter the port number. (Default: 21)
(6) Enter the timeout (Default: 20 sec)
- The timeout is the time required to disconneted automatically, if you do not use after connecting to the FTP server.
(7) If you press the OK button, setting the parameters to use FTP is completed.
(8) When you execute [Online] [Write Parameter], the parameters are written in the motion controller.
Note
1. Unless you set the user ID and password, basic ID and password will be set initially
- Default setting ID: LSIS
- Default password: 0000
2. Rules for applying the user ID and password
- You can enter the user ID and password that are composed of alphabetical characters and numbers
but special characters are not available.
- They must be case-sensitive and must not exceed the maximum of 8 digits.
To Next Page
Loading...
