MacDon D1 Series - Assembling 13.7 M (45 Ft.) Header (Split Frame); Unpacking Header

215184 86 Revision A
3.3 Assembling 13.7 m (45 ft.) Header (Split Frame)
Perform all procedures in this chapter in the order in which they are listed.
(Continued from 2.4 Lowering Header, page 16.)
Unless otherwise specified, discard all shipping material and hardware.
3.3.1 Unpacking Header
1016767
A
B
Figure 3.166: Left Endshield Shipping Position
1. Remove shipping wire securing left endshield (A) to frame.
2. Remove left endshield and brackets (B) from cutterbar.
1016756
A
A
Figure 3.167: Left Endshield Shipping Brackets
3. Remove hardware securing shipping brackets (A) to the
inside of left endshield and discard brackets.
ASSEMBLING THE HEADER AND FLOAT MODULE