MacDon D1 Series - Calibrating Feeder House Fore-Aft Tilt Range - John Deere S and T Series

215184 442 Revision A
1003959
A
B
Figure 9.301: Combine Display
NOTE:
When the AHHC is engaged, AHHC icon (A) appears on the
monitor and the number indicating which button was
pressed (B) is displayed on the screen.
Calibrating Feeder House Fore-Aft Tilt Range – John Deere S and T Series
For best performance of the auto header height control (AHHC), perform these procedures with the center-link set to D.
When setup and calibration are complete, adjust the center-link back to desired header angle. For instructions, refer to the
header operator’s manual.
This procedure applies only to model year 2015 and later John Deere S and T Series combines.
NOTE:
Changes may have been made to the combine controls or display since this document was published. Refer to the combine
operator’s manual for updates.
1016141
C
D
Figure 9.302: John Deere Control Handle
The feeder house fore/aft tilt is controlled by buttons (C)
and (D) at the back of the control handle.
SETTING UP AUTO HEADER HEIGHT CONTROL