215184 257 Revision A
Chapter 8: Performing Predelivery Checks
This machine has been set at the factory and should not require further adjustments; however, the following checks will
ensure your machine provides maximum performance. If adjustments are necessary, follow the procedures in this chapter.
WARNING
To avoid bodily injury or death from unexpected startup of machine, always stop engine and remove key before
adjusting machine.
IMPORTANT:
To avoid machine damage, check that no shipping material has fallen into the machine.
1. Shut down the engine, and remove the key from the ignition.
2. Perform the final checks as listed on the Predelivery Checklist (yellow sheet attached to this instruction – Predelivery
Checklist, page 519) to ensure the machine is field-ready. Refer to the following pages for detailed instructions as
indicated on the Checklist. The completed Checklist should be retained by either the Operator or the Dealer.
8.1 Checking Tire Pressure – Transport and Stabilizer Wheels
Check tire inflation pressure. If necessary, inflate tires according to the following table:
Table 8.1 Tire Inflation Pressure
Size
Load Range
Pressure
ST205/75 R15
D
448 kPa (65 psi)
E
552 kPa (80 psi)
IMPORTANT:
Do NOT exceed maximum pressure specified on tire sidewall.
To Next Page
Loading...
