215184 203 Revision A
6.3.3 Replacing CR Feeder Deflectors
If the header is configured for a New Holland CR 960, 9070, or 9080 combine, the float module has a factory-installed
feeder deflector kit to improve feeding into the feeder house. The kit can be replaced if necessary.
DANGER
To avoid bodily injury or death from unexpected start-up or fall of a raised machine, always stop engine and remove
key before leaving the operator’s seat, and always engage safety props before going under the machine for any reason.
IMPORTANT:
This information applies to CR model combines only. For CX model combines, kits must be removed.
The D1 Series/FM100 combine completion package for New Holland models includes both a short feeder kit (installed at
the factory) and a long feeder kit for narrow feeder house combines. For specifications, refer to Table 6.2, page 203.
Table 6.2 FM100 Feeder Kits for CR Model Combines
Combine Model Feeder House Size Feeder Kit Size
CR970, 9070, 9080
Medium
Short: 200 mm (7–7/8 in.)
CR960, 9060, 940, 9040
Narrow
Long: 325 mm (12–3/4 in.)
If required, replace the feeder deflectors as follows:
Figure 6.67: Side View of Deflector
1. Determine the position of existing deflector (A) by
measuring gap (X) between the deflector’s forward edge
and the pan. Record this measurement.
Figure 6.68: Replacement Deflector – Left Shown,
Right Opposite
2. Remove two bolts and nuts (B) securing deflector (A) to the
float module frame and remove deflector.
3. Position the replacement deflector and reinstall bolts and
nuts (B). Do NOT tighten bolts.
FLOAT MODULE SETUP AT DEALER
To Next Page
Loading...
