215184 391 Revision A
Calibrating Reel Height Sensor – CLAAS 8000/7000 Series
WARNING
Clear the area of other persons, pets etc. Keep children away from machinery. Walk around the machine to be sure no
one is under, on, or close to it.
NOTE:
Changes may have been made to the combine controls or display since this document was published. Refer to the combine
operator’s manual for updates.
1. Place header off the ground 15–25 cm (6–10 in.).
IMPORTANT:
Do NOT turn off the engine. The combine has to be at full idle for the sensors to calibrate properly.
Figure 9.196: CEBIS Main Page
2. From the main page, select FRONT ATTACHMENT (A).
Figure 9.197: Front Attachment Page
3. Select LEARNING PROCEDURES FOR FRONT
ATTACHMENT (A).
4. Select LEARNING REEL HEIGHT (B).
SETTING UP AUTO HEADER HEIGHT CONTROL
To Next Page
Loading...
