MacDon D1 Series - Setting up Auto Header Height Control - New Holland CR;CX Series

215184 465 Revision A
Setting up Auto Header Height Control – New Holland CR/CX Series
NOTE:
Changes may have been made to the combine controls or display since this document was published. Refer to the combine
operator’s manual for updates.
NOTE:
For New Holland CR models 6.80, 6.90, 7.90, 8.90, 9.90, and 10.90, refer to 9.1.19 New Holland Combines – CR Series –
2015 and Later, page 472.
1003581
Figure 9.358: New Holland Combine Display
1. Select HEADER LATERAL FLOAT on the combine display, and
press ENTER.
2. Use the up and down navigation keys to move between
options, and select INSTALLED.
1003582
Figure 9.359: New Holland Combine Display
3. Select HEADER AUTOFLOAT, and press ENTER.
4. Use the up and down navigation keys to move between
options, and select INSTALLED.
SETTING UP AUTO HEADER HEIGHT CONTROL