215184 127 Revision A
Figure 3.268: Left Shown, Right Opposite
3. Raise end of reel with a forklift or crane so the reel lift
cylinder can be attached.
4. Retrieve the cylinder wired to reel support arm.
5. Remove pins from lug on endsheet and reel arm.
6. Lift reel so reel lift cylinder mounting holes line up with
hole in reel arm (A) and lug on endsheet (B).
7. Secure cylinder to endsheet and reel arm with pins
as shown.
• Insert cotter pin OUTBOARD at reel arm (A).
• Insert cotter pin INBOARD at endsheet (B).
Figure 3.269: Center of Reel
8. Remove sling (A) and position it around reel tube near reel
center support arm.
9. Lift reel to access the center lift cylinder.
10. Remove shipping wire securing lift cylinder to center reel
arm. Remove packing.
ASSEMBLING THE HEADER AND FLOAT MODULE
To Next Page
Loading...
