MacDon D1 Series - Page 19

215184 xvii Revision A
Chapter 6: Float Module Setup at Dealer....................... ....................................................................... 175
6.1 Installing Filler Cap.............................................................................................................................. 175
6.2 FM100 Feed Auger Configurations......................................................................................................... 178
6.2.1 Converting from Ultra Narrow Configuration or Narrow Configuration to Medium Configuration ............. 181
6.2.2 Converting from Wide Configuration to Medium Configuration.......................................................... 183
6.2.3 Converting from Medium Configuration or Wide Configuration to Narrow Configuration........................ 185
6.2.4 Converting from Ultra Narrow Configuration to Narrow Configuration ................................................ 187
6.2.5 Converting from Medium Configuration to Wide Configuration or Ultra Wide Configuration ................... 188
6.2.6 Converting from Ultra Narrow or Narrow Configuration to Wide or Ultra Wide Configuration ................. 190
6.2.7 Converting from Wide Configuration to Ultra Wide Configuration ...................................................... 192
6.2.8 Converting from Medium Configuration or Wide Configuration to Ultra Narrow Configuration ................ 192
6.2.9 Converting from Narrow Configuration to Ultra Narrow Configuration ................................................ 196
6.2.10 Installing Feed Auger Fingers ...................................................................................................... 198
6.2.11 Removing Feed Auger Fingers..................................................................................................... 200
6.3 FM100 Stripper Bars and Feed Deflectors ............................................................................................... 202
6.3.1 Removing Stripper Bars............................................................................................................... 202
6.3.2 CR Feeder Deflectors .................................................................................................................. 202
6.3.3 Replacing CR Feeder Deflectors .................................................................................................... 203
Chapter 7: Attaching Header to Combine ............................................................................................. 205
7.1 AGCO (Challenger, Gleaner, and Massey Ferguson) Combines..................................................................... 205
7.1.1 Attaching Header to an AGCO (Challenger, Gleaner, or Massey Ferguson) Combine ............................... 205
7.1.2 Installing Reel Fore-Aft / Header Tilt Selector Switch and Harness ...................................................... 209
7.2 AGCO IDEAL
™
Series Combines ............................................................................................................. 213
7.2.1 Attaching Header to an AGCO IDEAL
™
Series Combine ..................................................................... 213
7.2.2 Installing Reel Fore-Aft / Header Tilt Selector Switch ........................................................................ 216
7.3 Case IH Combines............................................................................................................................... 218
7.3.1 Attaching Header to Case IH Combine ........................................................................................... 218
7.4 CLAAS Combines ................................................................................................................................ 224
7.4.1 Attaching Header to CLAAS Combine ............................................................................................. 224
7.5 John Deere Combines.......................................................................................................................... 229
7.5.1 Attaching Header to John Deere Combine ...................................................................................... 229
7.5.2 Installing Reel Fore-Aft / Header Tilt Switch – S and T Series Combines................................................ 232
7.5.3 Installing Reel Fore-Aft / Header Tilt Switch – 60 and 70 Series Combines ............................................ 239
7.6 New Holland Combines ....................................................................................................................... 244
7.6.1 Attaching Header to New Holland CR/CX Combine........................................................................... 244
7.7 Completing Header Assembly ............................................................................................................... 249
7.7.1 Positioning Transport Lights ......................................................................................................... 249
7.7.2 Crop Dividers ............................................................................................................................ 250
Removing Crop Dividers from Storage .......................................................................................... 250
Installing Crop Divider without Latch Option.................................................................................. 250
Installing Crop Divider with Latch Option ...................................................................................... 252
Installing Crop Divider Rods ........................................................................................................ 253
7.7.3 Installing Left Endshield – Split-Frame Headers................................................................................ 254
TABLE OF CONTENTS