Introduction
This instruction manual describes the unloading, setup, and predelivery requirements for the MacDon D1 Series Combine
Draper Header with FM100 Float Module.
To ensure the best performance of this product and the safety of your customers, carefully follow the unload and assembly
procedure from the beginning through to completion.
Some sections/steps do not apply to all header configurations and sizes. Refer to the instructions for your specific header.
Carefully read all the material provided before attempting to unload, assemble, or use the machine.
Retain this instruction for future reference.
Conventions
The following conventions are used in this document:
• Right and left are determined from the operator’s position. The front of the header faces the crop.
• Unless otherwise noted, use the standard torque values provided in this manual.
NOTE:
Keep your MacDon publications up-to-date. The latest version can be downloaded from our Dealer portal
(https://portal.macdon.com) (login required).
This document is currently available in English only.
215184 i Revision A
To Next Page
Loading...
