215184 293 Revision A
Figure 8.59: FM100 Grease Point Decal
Figure 8.60: Single-Knife Header Grease Point Decal
Figure 8.61: Double-Knife Header Grease Point Decal
2. Wipe grease fitting with a clean cloth before greasing to
avoid injecting dirt and grit.
IMPORTANT:
Use clean, high-temperature, extreme-pressure grease only.
3. Inject grease through fitting with grease gun until grease
overflows fitting (except where noted).
4. Leave excess grease on fitting to keep out dirt.
5. Replace any loose or broken fittings immediately.
6. Remove and thoroughly clean any fitting that will not take
grease. Also clean lubricant passageway. Replace fitting if
necessary.
PERFORMING PREDELIVERY CHECKS
To Next Page
Loading...
