Safety Precautions
12
High-function General-purpose Inverter RX2 Series User’s Manual
Do not store or use the product in the following places.
• Locations subject to direct sunlight.
• Locations subject to ambient temperature exceeding the specifications.
• Locations subject to relative humidity exceeding the specifications.
• Locations subject to condensation due to severe temperature fluctuations.
• Locations subject to corrosive or flammable gases.
• Locations subject to exposure to combustibles.
• Locations subject to dust (especially iron dust) or salts.
• Locations subject to exposure to water, oil, or chemicals.
• Locations subject to shock or vibration.
• Do not drop or apply strong impact on the product. Doing so may result in damaged parts or malfunc-
tion.
• Do not hold by the front cover and terminal cover, but hold by the fins during transportation.
• Confirm that the rated input voltage of the inverter is the same as AC power supply voltage.
• Do not connect an AC power supply voltage to the control input/output terminals. Doing so may result
in damage to the product.
• Be sure to tighten the screws on the terminal block securely. Wiring work must be done after install-
ing the unit body.
• Do not connect any load other than a three-phase inductive motor to the U, V, and W output termi-
nals.
• Take sufficient shielding measures when using the product in the following locations. Not doing so
may result in damage to the product.
Locations subject to static electricity or other forms of noise.
Locations subject to strong magnetic fields.
Locations close to power lines.
• When using DriveProgramming, confirm that the program data is downloaded normally before start-
ing operation.
• Connect the PG Unit to the Inverter tightly with fixing screws. In addition, be sure to connect terminal
wires on the PG Unit securely.
Precautions for Safe Use
Installation and Storage
Transportation, Installation, and Wiring
To Next Page
Loading...
Need help?
General