Omron RX2 Series - Concurrent Monitor Mode

3 Operation
3 - 18
High-function General-purpose Inverter RX2 Series User’s Manual
When configuring settings such as frequency command and acceleration/deceleration time while
watching the monitor during operation, you can change the settings on this monitor screen.
Monitor screen - Parameter selection screen
3-2-2 Concurrent Monitor Mode
Set-up procedure Action
Press the Enter key to change the color of parameter field.
(Tips)
Using the up and down ( ) keys, you can choose
to change the parameter or change the monitor.
When the Enter key is pressed again, the left-most letter of
the parameter can be changed.
Using the arrow ( ) keys to change
the parameter number that you want to change, and then
press the Enter key.
Example1) When the frequency command destination
[AA101] First speed command selection is
changed.
Example2) When the frequency command value is con-
trolled in [FA-01] while the frequency command
destination is set to 07: Parameter setting.
On the screen that is displayed upon power-on,
using the right and left ( ) keys, navigate
to a setting screen “Concurrent monitor” (H03).
Menu
Optional
device
0.00Hz
oFW
STOP
M1
H03
Output Frequency
0.00 Hz
FA-01
0.00 Hz
[0.00-60.00]
Output Frequency
0.00 Hz
FA-01
0.00 Hz
[0.00-60.00]
Output Frequency
0.00 Hz
FA-01
0.00 Hz
[0.00-60.00]
Output Frequency
0.00 Hz
AA101
First main speed command selection
07: Parameter set-up