3 - 3
3 Operation
High-function General-purpose Inverter RX2 Series User’s Manual
3-1 Overview of LCD Operator
3
3-1-1 Part Names and Descriptions
3-1 Overview of LCD Operator
Overview of LCD Operator is described.
This section describes the overview in the state that date and time are displayed in trip history and in
retry history. In purchasing, the date and the time are not displayed. Instead, “-” is displayed. If you
desire to display them, refer to section 3-1-5 How to Set Battery and the Time Setting on page 3-12,
and set optional batteries (CR2032, 3V) to the LCD operator in order to operate clock function.
Name and function of each part of the LCD Operator is described below.
3-1-1 Part Names and Descriptions
1. LCD Operator
Operates to set parameter constants, monitors, perform operation
and stop.
2. LCD Display
Displays the frequency reference value, output frequency, parame-
ter constant and other relevant data.
3. Power Supply Lamp (POWER)
Lights in green when power is supplied to the LCD Operator. When
power is supplied to R0 and T0 in the main circuit and to P+ and P-
in the terminal block, it is lit.
4. Operation Lamp (RUN)
Lights in green when operation is commanded.
5. Operation keys
Operating section for indicating and settings.
To Next Page
Loading...
Need help?
General