3.
The SNMP V1/V2c Settings for Access window will display:
4.
Enter the required information in the fields provided:
The IP Version field provides a choice of IPv4, IPV6 or both IPv4 and IPv6 (=
default).
The choices offered below will change in context with the choice made in the
IP Version field.
If no value is entered in the IPv4 and/or IPv6 field, SecureSync uses the sys-
tem default address.
SNMP Community names should be between 4 and 32 characters in length.
Permissions may be Read Only or Read/Write.
The Version field provides a choice of V1 or V2c.
5.
Click Submit. The created communities will appear in the SNMP V1/V2 panel:
Editing and Deleting Communities
To edit or delete a community you have created:
88
CHAPTER 2 • SecureSync 2400 User Manual Rev. 2
2.14 Configure Network Settings
To Next Page
Loading...
Need help?
General
