Caution: Ensure that the ribbon cable is aligned and fastened prop-
erly to all pins on the connector of the card, before powering the unit
up, to avoid damage to the equipment.
5.2.2.8 [5]: Bottom Slot Installation
Instructions for installing an option card into one of the bottom slots (3, or 5):
a.
Safely power down the unit and remove the top cover of the main chassis (housing).
Save the screws.
DANGER! SecureSync does not have an ON/OFF switch. It is neces-
sary to unplug the machine to remove power!
Caution: NEVER install an option card from the rear of the unit,
ALWAYS from the top, after removing the chassis cover.
b.
Remove the blank option card plate, or the existing option card in the slot. Save the
screws.
If a card is populating the slot above the bottom slot your option card is to be
installed into, remove it temporarily (also remove and save the standoffs for reuse).
c.
Insert the card into the bottom slot by carefully pressing its connector into the main-
board connector (see Figurebelow), and by lining up the screw holes on the card
with the screw holes on the chassis.
346 SecureSync 2400 User Manual
APPENDIX
To Next Page
Loading...
Need help?
General
