Note: Whether or not notifications are enabled/disabled for a given event,
the occurrence of the event is always logged.
All available SecureSync events that can generate a notification to be sent are located
under different tabs in the Notification Events panel: Timing, GPS, and System.
The SecureSync Events that can automatically trigger a notification are listed in the Event
column. It is possible to:
Mask the alarm generation for specific events (prevent the alarm)
Enable “SNMP” (to send out an SNMP trap)
Send an email to the address specified in the corresponding “Email Address”
column.
4.2.1 Configuring Notifications
To configure Notifications:
1.
Navigate to MANAGEMENT > OTHER: Notifications. The Notifications screen
will display:
It is divided into two panels:
The Actions panel, featuring:
The SNMP Setup button: See "SNMP" on page83.
The Email Setup button: Configure SecureSync's interface settings
for Exchange email servers and Gmail.
For more information on this subject, see the Technical Note Email
Notification Setup.
242
CHAPTER 4 • SecureSync 2400 User Manual Rev. 2
4.2 Notifications
To Next Page
Loading...
Need help?
General
