Orolia SecureSync 2400 User Manual

After installing power supplies, functionality can be confirmed through the Web UI or by
using the CLI command HS_GetStatus 0
2.10 Powering Up the Unit
1.
After installing your SecureSync unit, and connecting all references and network(s),
verify that power is connected, and wait for the device to boot up.
Note: SecureSync does not have a power switch. When the unit is
plugged in, the power will be on (unless you have an additional con-
dition, such as your unit has been halted).
2.
Observe that the front panel illuminates The time display will reset and then start
incrementing the time.
Figure 2-2: SecureSync front panel
3.
Check the front panel status LED indicators:
The Power LED should be lit (not flashing).
The GNSS LED will be either OFF or flashing HEARTBEAT, since syn-
chronization has not yet been achieved.
The Alarms LED light should be OFF (startup behavior) or HEARTBEAT
(acquiring fix behavior). A FAST blinking pattern would indicate the unit
requires attention.
For additional information, see "Status LEDs" on page4 and "Status Monitoring via Front
Panel" on page279.
2.10 Powering Up the Unit
CHAPTER 2 • SecureSync 2400 User Manual Rev. 2
47

Orolia SecureSync 2400 Specifications

General

Brand	Orolia
Model	SecureSync 2400
Category	Recording Equipment
Language	English