Orolia SecureSync 2400 - Monitoring the Oscillator

To display the settings of an output:
1.
Navigate to INTERFACES > OUTPUTS, and click on the desired output (recessed e.g.,
PPS Output 0):
2.
The corresponding Status window will display:
Click the Edit button in the bottom-left corner to configure settings that are user-editable.
See also "Configuring Outputs" on page148.
4.5.1.7 Monitoring the Oscillator
The Oscillator Management screen provides current and history status information on dis-
ciplining state and accuracy.
To access the Oscillator Management screen:
4.5 Quality Management
CHAPTER 4 • SecureSync 2400 User Manual Rev. 2
289