Orolia SecureSync 2400 User Manual

2.11 Zero Configuration Setup
As an alternative to conventional network configuration, SecureSync can also be set up
using the zero-configuration networking technology ("zeroconf").
Note: You can use Zeroconf on either Ethernet port if DHCP is enabled.
Zeroconf must be used with a DHCP server.
When using zeroconf, a TCP/IP network will be created automatically, i.e. without the
need for manual configuration: Once SecureSync's ETH connector is connected to a net-
work, you can directly access the SecureSync WebUI, using a standard web browser,
without any configuration.
Zeroconf can be used to connect to the unit through the Web UI:
when you need to identify the IP address assigned to your unit through DHCP
in circumstances when your unit is not connected directly to a PC
when you wish to access the Web UI of your SecureSync without using the CLI com-
mands or serial connection
anytime the IP address of a unit is not known (for instance, if you have "lost" your
unit on a network).
Zeroconf Requirements
Prior to using zeroconf, ensure the following requirements are met:
Your network is DHCP enabled, and DHCPis enabled on the individual ETH port you
are using (this is the default setting).
The PC you will use to communicate with your unit is connected to the same net-
work as your SecureSync.
Windows 7/8 users should install Bonjour Print Services, otherwise access to
*.local addresses will not be possible.
Windows 10 already supports mDNS and DNS-SD, hence there is no need to install
additional software.
48
CHAPTER 2 • SecureSync 2400 User Manual Rev. 2
2.11 Zero Configuration Setup

Orolia SecureSync 2400 Specifications

General

Brand	Orolia
Model	SecureSync 2400
Category	Recording Equipment
Language	English