LOGS
To clear all current logs stored on SecureSync, click CLEAR LOGS.
To start a new log session, click NEW LOG SESSION.
To download current logs, click DOWNLOAD LOGS.
Broadshield Notifications
You can setup Notifications to be sent if BroadShield detects or clears an alarm:
Navigate to MANAGEMENT: OTHER > Notifications, and under the GPS tab, loc-
ate the two BroadShield line items. For further information on how to configure Noti-
fications, see "Notifications" on page241.
3.3.3 The GNSS Reference
With most applications, SecureSync will be setup such that it utilizes a GNSS signal as the
primary (if not the only) timing reference.
SecureSync's GNSS receiver utilizes the signal provided by the GNSS antenna.
The GNSS receiver analyzes the incoming GNSS data stream and supplies the GNSS time
and 1PPS (Pulse-Per-Second) signal to SecureSync's timing system. The timing system
uses the data to control the System Time and discipline the oscillator.
While SecureSync’s default GNSS receiver configuration will likely be adequate for most
applications, it is advisable that you review the options and change settings as needed, par-
ticularly if you are experiencing poor signal reception.
3.3 Managing References
CHAPTER 3 • SecureSync 2400 User Manual Rev. 2
203
To Next Page
Loading...
Need help?
General
