7.
The SNMP trap you created will appear in the SNMP Traps panel:
Each row of the SNMP Traps panel includes the version of the SNMP functionality,
the User/Community name for the trap, the IP address/Hostname of the SNMP
Manager and values applicable only to SNMP v3, which include the Engine ID, the
Authorization Type, the Privilege Type.
You may define different SNMP Managers to whom SNMP traps can be sent over
the network. This allows for SNMP Managers in different geographical areas to
receive the same SNMP traps.
Note: Spectracom has been assigned the enterprise identifier 18837
by the IANA (Internet Assigned Numbers Authority). Spectracom’s
product MIBs reside under the enterprise identifier @18837.3.
For detailed descriptions of the objects and traps supported by the SecureSync,
please refer to the Spectracom SecureSync MIB files. See "Accessing the SNMP
Support MIB Files" on page86.
2.14.9 VLAN Support
VLAN support in SecureSync allows you to assign a VLAN ID to a specific port to facilitate
communication within your network. These VLAN interfaces have the same configuration
options as the standard untagged Ethernet interfaces.
To set up VLAN interface identification tags:
1.
Navigate to MANAGEMENT > Network Setup. In the Actions panel, select VLAN.
2.
In the popup panel labeled VLAN Setup, click on the plus sign to add your VLAN
interfaces. (You can also view or delete any configured VLAN tags from this panel).
2.14 Configure Network Settings
CHAPTER 2 • SecureSync 2400 User Manual Rev. 2
93
To Next Page
Loading...
Need help?
General
