To access the GNSS Receiver settings:
1.
Navigate to INTERFACES > REFERENCES: GNSS 0.
Note: Typically, there will be only one GNSS reference, numbered
"0".
2.
The GNSS 0 status window will open. To open the configuration window, click Edit
in the bottom-left corner.
OR:
1.
Navigate to INTERFACES > REFERENCES: GNSS Reference.
2.
Click on the INFO button, or the GEAR button to configure the GNSS settings, or
review GNSS reference status information.
3.3.3.1 Reviewing the GNSS Reference Status
To view the current status of your GNSS reference:
1.
Navigate to INTERFACES > REFERENCES: GNSS Reference.
2.
Click the INFO button next to GNSS 0. The GNSS 0 status window will display; it
contains two tabs, explained in detail below: Main [= default], and Satellite Data.
The "Main" tab
204
CHAPTER 3 • SecureSync 2400 User Manual Rev. 2
3.3 Managing References
To Next Page
Loading...
