Network Transport: [Ethernet, IPv4/UDP] Selects the transport protocol used for
PTP packets.
Management Mechanism tab
Request Peer Information: [ON/OFF] Enable/disable management requests.
Request Peer Information Rate: [0.2 = one request every five seconds] Request
rate in seconds for PTP Management messages.
Respond to Peer Information Requests: [ON/OFF] Enable/disable management
responses.
Network tab
Multicast Ttl: [1 through 255] Time-to-live (packet lifespan) — Sets the TTL field
for PTP packets except for Peer-to-Peer packets for which TTL is forced to 1 as spe-
cified in IEEE Std 1588-2008 Annex D.3.
Unicast Ttl: [64] Time to live for Unicast packets.
2.16.1.2 The PTP Statistics Panel
This panel provides statistics for each Ethernet port. If the PTP is set to OFF for a specific
port, this screen will not display any information.
All statistics shown are based on the traffic that is detectable by SecureSync, i.e. in a
Unicast environment, SecureSync may only detect traffic that is addressed to it, based on
switch configuration.
Figure 2-8: PTP Statistics Panel
PTP Node: IP address of PTPnode.
Clock Identity: [e.g., "a0:36:9f:ff:fe:37:b9:5d"]
2.16 Configuring PTP
CHAPTER 2 • SecureSync 2400 User Manual Rev. 2
133
To Next Page
Loading...
Need help?
General
