1.8 Regulatory Compliance
This product has been found to be in conformance with the following regulatory pub-
lications.
FCC
This equipment has been tested and found to comply with the limits for a ClassA digital
device, pursuant to Part15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference
when the equipment is operated in a commercial environment. This equipment gen-
erates, uses, and can radiate radio frequency energy and, if not installed and used in accord-
ance with the user documentation, may cause harmful interference to radio
communications.
Operation of this equipment in a residential area is likely to cause harmful interference
in which case the user will be required to correct the interference at his/her own expense.
Note: This is a Class A product. In a domestic environment this product may
cause radio interference in which case the user may be required to take
adequate measures.
Safety
This product has been tested and meets the requirements specified in:
IEC 62368-1:2014
EN 62368-1:2014 +A11:2017
UL 62368-1:2014
CAN/CSA-C22.2 NO. 62368-1-14
EMC Compliance
This product has been tested and meets the following standards:
EN 55032:AC:2016
ICES-003 Issue 6: Class A
FCC CFR 47 PART 15 SubPart B: 2020
EN55035:2017: Class A
AS/NZS CISPR 32:2015/AMDI1.2019
Radio Spectrum Efficiency: EN 301 489-1 V2.2.3 (2019-11) and EN 301 489-17
V3.2.2 (2019-12)
1.8 Regulatory Compliance
CHAPTER 1 • SecureSync 2400 User Manual Rev. 2
33