DANGER! SecureSync does not have an ON/OFF switch. It is neces-
sary to unplug the machine to remove power!
Caution: NEVER install an option card from the rear of the unit,
ALWAYS from the top, after removing the chassis cover.
3.
Select one of the unused Slots as installation location for the new card. The chosen
Slot determines the installation procedure (see "[3]: Determining the Installation
Procedure" on page342).
4.
Prepare slot (if required), and plug card into the slot.
5.
Connect any required cables and secure option card into place.
6.
Replace chassis cover, power on unit.
7.
Log in to the SecureSync web interface; verify the installed card is identified.
8.
Restore SecureSync configuration (if it had been backed up before, see above).
5.2.2.3 Safety
Before beginning any type of option card installation, please carefully read the safety state-
ments and precautions under "SAFETY" on page39.
5.2.2.4 [1]: Unpacking
On receipt of materials, unpack and inspect the contents and accessories (retain all original
packaging for use in return shipments, if necessary).
The following additional items are included with the ancillary kit for the field installation of
option card(s). Some of the parts listed below will be required for the installation (depend-
ing upon option card model, and installation location).
340 SecureSync 2400 User Manual
APPENDIX
To Next Page
Loading...
Need help?
General
