NTP ON/OFF: This switch enables and disables NTP. See "Dis-/Enabling NTP"
below.
Note: When applying any changes NTP will usually restart auto-
matically. Use this switch only to force a restart.
Other NTP Services that can be configured via the NTP Services panel by clicking the
GEAR icon are:
Stratum 1 (see "NTP Reference Configuration" on page102)
The NTP Status Summary panel
… provides a real-time overview of your key NTP network parameters. For more inform-
ation, see .
2.15.3 Dis-/Enabling NTP
If you applied NTP configuration changes e.g., added a new NTP Server, SecureSync usu-
ally will stop and re-start the NTP Service automatically once you clicked Submit. Changes
made to NTP configurations will also take effect after SecureSync is either rebooted or
power-cycled.
You can, however, also disable or enable the SecureSync NTP Service manually.
To disable and enable your NTP Service:
1.
Navigate to MANAGEMENT > NETWORK: NTP Setup.
2.
In the NTP Services panel, set the ON/OFF toggle switch to OFF.
3.
A notification window will confirm the status change.
4.
In the NTP Services panel, set the ON/OFF toggle switch to ON again.
Changes made will now take effect and NTP operation will be restored shortly after this
operation is performed.
2.15.4 Viewing NTP Clients
To view the NTP clients being served by SecureSync:
2.15 Configure NTP
CHAPTER 2 • SecureSync 2400 User Manual Rev. 2
99
To Next Page
Loading...
Need help?
General
