2.3 Required Tools and Parts
Depending on your application and system configuration, the following tools and parts may
be required:
Phillips screwdrivers to install the rack-mount ears, and to mount the unit in a 19"-
rack
Ethernet cables (see "Connecting Network Cables" on page44).
2.3.1 Required GNSS Antenna Components
Should you plan on using a GNSS reference with your SecureSync, you will also need the
following items (sold separately):
Antenna cable with SMA connector, or conversion cable
Note: The SMA-to-N-type conversion cable included in the ancillary
kit is approved for pull weight of up to 60 lbs. If you are using a heav-
ier cable, you will need to apply appropriate strain relief.
GNSS antenna with mounting bracket
GNSS antenna surge suppressor (recommended)
GNSS antenna inline amplifier (optional for short cable lengths)
For antenna installation guidelines, see the separate documentation shipped with the
antenna components.
38
CHAPTER 2 • SecureSync 2400 User Manual Rev. 2
2.3 Required Tools and Parts
To Next Page
Loading...
Need help?
General
