Orolia SecureSync 2400 User Manual

Note: Once a survey has been initiated, the Survey Progress may not
be displayed right away until the receiver has completed its ini-
tialization process.
3.3.3.6 GNSS Receiver Offset
The Offset setting in the GNSS configuration window (INTERFACES > GNSS 0 > "Edit")
allows you to enter an offset to the GNSS time and 1PPS reference in order to account for
antenna cable delays or other latencies (entered and displayed in nanoseconds).
By setting the correct Offset value, you can offset the system’s on-time point by the Off-
set value to compensate for the antenna and in-line amplifier delays. Under typical con-
ditions, the expected cable and amplifier delays are negligible. You can calculate the delay
based on the manufacture’s specifications.
The offset range is ±½ seconds (i.e. ±500ms, or ±500000000 ns). The default value is
0nanoseconds, and the resolution is 1 nanosecond.
Configuring a GNSS receiver offset
To configure the GNSS receiver offset:
1.
Navigate to Interfaces > References: GNSS Reference
2.
Click on the GEAR button next to the GNSS Reference. The GNSS0 window will
open:
3.3 Managing References
CHAPTER 3 • SecureSync 2400 User Manual Rev. 2
215

Orolia SecureSync 2400 Specifications

General

Brand	Orolia
Model	SecureSync 2400
Category	Recording Equipment
Language	English