The Events panel, offering three tabs:
Timing: Events for Sync Status and Holdover, Frequency error, Input
references and the internal oscillator.
GPS: Events related to the GNSS receiver, including antenna cabling,
tracking less than the minimum number of satellites and GNSS receiver
faults.
Systems: Events related to the system operation, including minor and
major alarms being asserted, reboot, timing system errors and option
cards.
2.
In the Events panel, choose the Timing, GPS or System tab. Configure your Noti-
fications (see below), and click Submit.
The columns under each tab are:
Event—This is the event that will trigger the notification. The events under
each tab will vary according to context.
Mask Alarm—Check here to enable an alarm mask. Enabling an alarm mask
for a given notification will prevent that notification from generating an alarm
condition. Other notifications for that event and logging of the event will still
occur.
SNMP Trap—Check here to configure the event to trigger an SNMP Trap.
Email—Check here to configure the event to trigger an email notification.
Email Address—Enter the address to which the email should be sent when
triggered by the event.
4.2 Notifications
CHAPTER 4 • SecureSync 2400 User Manual Rev. 2
243
To Next Page
Loading...
Need help?
General
